Descrizione
InfoProdotto
AluBurn is a soft, absorbent and low-adherent wound dressing, made of nonwoven fibers, carded and needle
punched to form a nonwoven absorbent felt ,which is laminated with a non-adherent Aluminized
Polyethylene net, forming the wound contact layer.
a- Aluminized polyethylene net:
• Acts as a non-adherent layer, so it does not stick to the newly formed tissue.
• Permeable, it allows free passage of wound exudate preventing skin maceration.
b- Hydrophilic absorbent fleece.
c- Soft and conformable.
d- permeable to air/water vapor
– Burn and chemical burn.
– Used for wounds caused by skin grafting.
– Abrasion and minor cuts.
– In first aid and for emergency use.
– Can be used post-operatively to protect surgical wounds and incisions.
– Used for catheter, cannulas and tracheal cannulas for tracheostomies fixations.
There are no absolute contraindications to the use of the products, but don’t use on patients with known
sensitivity to the product or any of its components.
– Reuse of the product may cause risk of infection or cross-contamination.
– The dressing should not be used with highly exuding wounds as it may cause tissue maceration.
– The skin should be clear and dry before application to ensure good adhesion.
– Dispose as contaminated waste.
1. Open the pouch according to normal procedure.
2. Remove the flaps to expose the adhesive surface.
3. Place the dressing on the wound site.
4. In case of presence of upper support paper, slowly remove it while smoothing down transparent film dressing edges.
AluBurn Adhesive | Size | Pieces/Case | Boxes/Case |
ALUBAD5070 | 5x7cm | 10 | 48 |
ALUBAD6070 | 6x7cm | 10 | 48 |
ALUBAD6080 | 6x8cm | 10 | 48 |
ALUBAD5090 | 5x9cm | 10 | 48 |
ALUBAD6083 | 6×8.3cm | 10 | 48 |
ALUBAD50100 | 5x10cm | 10 | 48 |
ALUBAD6082 | 6×8.25cm | 10 | 48 |
ALUBAD6085 | 6×8.5cm | 10 | 48 |
Other sizes are available upon request
Recensioni
Ancora non ci sono recensioni.